-
Unattainable 1:1 magnification with the JJC FDA S-1 and Micro Nikkor 60 2,8
The JJC FDA S-1 does not allow a 1:1 magnification with the Micro Nikkor 60 2,8. It only reaches a smaller factor (about 80%.The probable reason is the excessive lenght of the original step-down ring.Using a thinner step-down ring, as it has been done in this video, does not improve the outcome.
-
Processing a DSLR Digitised Black and White Film with Affinity Photo
This videos shows how to process a Black and White film digitised with a DSLR camera.The process starts from opening the RAW file in Affinity Photo’s Develop Persona. In short and in order, the steps are:
You May Also Like
The missing guest
A Manual-Focus Atteimpt on a Moving Target
Absence in Three Acts
-
DSLR film scanning: episode three
This is, by far, the most pleasing result I have ever had from digitising a film negative with a DSLR.Contrary to many suggestions found on Youtube, I did not invert the negative RAW curve by tweaking the Master RGB option. I did it, instead, channel-bychannel minding each clipping point. This approach allowed for a better reproduction of the grey tones, and in the end a fair result.
-
Another attempt at DLSR film scanning
Still trying.I digitised the negative with a Pentax K-1 and the FA 100 2.8 Macro lens using the JJC clone of Nikon ES-2. Postproduction is done in Pixelmator Pro. I used a Nikon 35TI and a Kodak BW400CN to take the original photo. Strangely enough, the JJC does not allow a 1:1 ratio with the Micro Nikkor 60 2.8.The instructions advise to mount the 62mm to 52mm step-down ring, the #2 52mm barrel-shaped tube and finally the film holder. These instructions are clearly wrong, as it is not possible to get 1:1 magnification with this setup.So I removed the tube and mounted the film carrier directly on the 62mm to…
-
An attempt at DSLR-made film digitization
This is the first usable result of the attempt to DSLR-scan films. I tried several approaches, including the standard tripod holding the camera perpendicularly to a flat, LED-lighted surface. However, I finally went for a different solution: a horizontal rig with two moving plates, a micrometric head holding the film and three-axis and a panoramic head holding the camera.
